Although the quality of enameled wire depends on the quality of raw materials such as paint and transmission lines and the objective conditions of mechanical equipment at a very large level, if the actual operation does not seriously complete a series of problems such as cake baking, quenching, and speed, and understand them Internal connection, not grasping the technicality of actual operation, not worrying about doing a good job in touring performances and parking arrangements, not doing a good job in the processing technology and environmental sanitation, even if the objective reasons are good, high-quality enameled wire cannot be produced. Therefore, the decision-making element for a good enameled wire is people.

Sense of mission.

  1. Catalytic combustion device warm air circulation system Before driving the enameling machine, the centrifugal fan must be turned on to make the gas in the furnace circulate the system at a slow speed. The furnace and the catalytic reaction zone are heated by electric heating, so that the temperature of the catalytic reaction zone reaches the required light-off temperature of the metal catalyst.

 2. "Sanqin" and "Three Checks" in actual production operations.

1) Diligent paint film Measure once every hour, and check the zero position of the micrometer card before the measurement. When measuring the line, the micrometer and the line are persistently at the same speed, and the large line should be measured in two mutually vertical directions.

2) Regular school line row often research the round-trip line row and the support force is tight, and immediately review. Check whether the grease is moderate.

3) Look at the surface frequently. Check the enameled wire for any potential safety hazards, such as particles, paint drop, etc., during the entire coating process. Find out the reason and review it immediately. For the unsatisfactory goods in the car, immediately lower the axle.

4) Check operation Check whether all running parts are normal, pay attention to the tightness of the pay-off shaft, to prevent rolling head, disconnection and cable wire diameter thinning.

5) Check three degrees Check temperature, speed and viscosity according to the processing technology regulations.